This page contains information, current updates, and pictures about all of my projects. I will try to keep the page updated weekly!
This is my first update about my submarine. It has been protyped using 3d printed parts and fiberglass resin. in the new model to power it, i have planned to use three water proof F540 3300KV, Brushless Motors to control my submarine. my submarine is not ballast tank based, but instead it is controlled by two tailfin props allowing it to angle itself up or down, then engage its primary motors.
This is my original submarine prototype using a fibrglass wrapped pringles can as a body that can withstand pressure and a set of 3d printed pontoons to act as ballast floats with a side steering motor on each pontoon.